Casio IT300 hard reset

Full Reset Casio IT300 and Soft reset

Resetting the Handheld Terminal
Resetting the terminal is the same as resetting a PC. Performing a reset causes all unsaved RAM data to be lost that are in mid-course of inputting and editing, but data and settings that are already stored in the FlashROM should be unaffected. Perform a reset to restore normal operation whenever the Handheld Terminal operates abnormally due to misoperation or some other reason.

Casio IT300 Soft reset

Use a pointed implement such as a mechanical pencil (with the lead retracted) to press the reset switch on the back of the terminal. This starts the reset operation.
* Do not use a toothpick or pencil or other sharp object whose tip may break off the reset switch.

Casio IT300 hard reset

Performing a Full Reset (Initialization) Performing, a full reset deletes all data and resets various settings to their defaults. *Data stored in the Flashdisk folder remain unaffected.
Perform a full reset whenever any one of the following,- conditions exists.

• When you want to delete installed programs and settings, and resume the terminal to the initial condition.

• When you are no longer able to use the Handheld Terminal because you forgot your password.

• When the Handheld Terminal does not operate normally due to a memory problem.

Important! Performing a full reset resets all data to their defaults except stored in the Flashdisk folder. If possible, backup data of the terminal to a PC or to the Flashdisk folder. The reset procedure and display message appeared on performing the reset is according to the model you operate.

1. While holding down the Fn key and CLR key. push down the reset switch for about 3 seconds with the tip of a pointed implement such as a mechanical pencil until the message shown below appears on the display.

• To cancel the full reset operation. press the MENU key.

2. Press the Trigger key. This causes the message shown below to appear.

• To cancel the full reset operation. press the MENU key.

3. Press the Trigger key again to perform the full reset.

• The full reset starts and all data in the memory are erased. and the start-up screen appears.

Data stored in the Flashdisk folder remain unaffected.