ViewSonic V35 hard reset

ViewSonic V35 soft reset

Resetting your V35

CAUTION: Resetting will cause unsaved data to be lost.
Resetting your V35 is similar to restarting your PC. It restarts the operating system, but you will lose any unsaved data. Occasionally, you may need to reset your V35. For example, you should reset your V35:
• After you restore data from your PC.
• When your V35 stops responding. (In other words, it appears to be “frozen” or “locked up.”)
Follow this procedure to reset your V35:
1 Remove the memory card (if installed).
2 Unscrew the tip of your stylus. Use the tip to press the reset button on the side of your V35.

ViewSonic V35 hard reset

Restoring Factory Defaults

In some cases, you may need to restore your V35 to the factory default settings by clearing the memory (RAM) from your V35. For example, you should clear the memory:

• When your V35 does not respond after being reset.
• When you forget your password.

Clearing the memory means all data you have entered in RAM, including all files, system settings, and additional programs you have installed, will be erased. (Programs installed to ROM at the factory are not affected.)

CAUTION:

• To ensure the integrity of your data should it be necessary to clear
the memory, you are advised to regularly back up to your PC (using
ActiveSync), or to an optional SD card (using the backup
application).
• Do not push the battery switch unless it is necessary

Follow this procedure to clear the memory from your V35:

1 Disconnect all cables, including the AC adapter, from your V35.
2 Unscrew the tip of the stylus. Use the tip to push the battery switch to the OFF (up) position.

3 Wait for three (3) minutes then push the battery switch to the ON (down) position.
4 The Notification indicator will flash red for approximately 30 seconds, and then your V35 will automatically turn on and display the Welcome Wizard screen.
NOTE: If the battery runs completely out of power and is not re-charged in time, the memory of your V35 will be cleared.